vracer111Have a Gen 1 Tisas B9R Duty I bought new from PSA a little over 2 years ago and did the following changes to it. Grip module: Warwick Tactical machined MJD Bald unit with MJD mag release and Dawson Precision pad. This grip module is now unobtanium as Warwick Tactical stopped doing all composite grip modules, which is a bummer because it's a really nice upgrade over stock - sticks very nicely to the hand with lots of grip but not rough and no hot spots. Magwell: Dark Side Precision Stacatto 2011 slim LoPro Trigger bow/shoe: Red Dirt Staccato fit flat, F4 length (fitting by removing material from bottom of the shoe until freely moves with no slop) Slide release: TriARC extended stainless (fitting required as had frame interference) Thumb safety: EGW HD stainless (fitting required to be able to insert and engage safety) Pins/MSH parts: EGW stainless set ([P/N 10031] sear/hammer, Main spring plunger, and slide release/thumb safety pins used) Main/hammer spring: Wilson Combat 19lb Guide Rod: Wilson Combat full length stainless setup with stainless open plug and flat recoil spring (13lb). Fitted rod by filing /stoning length down a bit to make easier to field strip Barrel bushing/compensator: Wilson Combat compensator (most time spent fitting/sanding down O.D. and checking with calipers for snug fit with slide. I.D. fine with barrel) RMR mount: LakeLine RMSc to RMR adapter plate (had to clearance the front overhang to be able to fit it on the slide). RMR optic: Holosun 507 Competition (red), also added an ADE Agvanced Optics Delrin 1MOA RMR footprint shim since could not get enough elevation (G1 optics cut issue). Extras Included: - Original 2 factory 17rd mags and 2 Prodigy 17rd mags with Underworld Arms +3 base plate extensions. - GRITR 1911 holster modded to fit the extended controls with Safariland QLS attachment and a belt low drop mount setup with crotch/upper thigh strap. - All removed stock parts - new EGW Stainless National Match Barrel bushing (needs ID honed to fit the barrel, OD and lug fits fine as is with the slide) [P/N 14801] - EGW Stainless Pin set (remainder of what I didn't use) [P/N 10031] - new Wilson Combat stainless HD Extractor [P/N 415-S70S] - new Wilson Combat 15lb flat recoil spring [P/N 614615] - new Wilson Combat firing pin spring [P/N 702CS] - new Wilson Combat Sear spring Really like how it shoots and have had no issues or complaints with it. Ran it on 124gr Blazer brass (chronoed @ 1108fps) and 125gr Hornady HAP bullet custom handloads (chronoed @ 986fps). Reason I'd like to sell is to get a 10mm 2011, specifically the Kimber DS warrior long slide. 10mm is my jam and the Kimber DS Warrior has been around just long enough to show it's been well designed with good GC & reliable near flawless operation. Can find full quality images of everything I have listed for this Tisas B9R Duty here: https://vracer111.smugmug.com/FS/B9R/n-nVKvF9 No Trades unless for a Kimber DS Warrior long slide 10mm. Price includes shipping.
